PNI KAP800D self-supporting gate automation kit, motor, photocells, remote control, lamp, 230V, 1100 N and 800KG sliding gate

Motor for automatic swing gates

The motor has a power of 350W and can open or close gates with a maximum weight of 800 kg.

The PNI KAP800D gate automation kit, with which this motor is compatible, includes all the components necessary to put a practical access control system into operation: the motor, warning light, two photocells and mounting accessories.

Remote control

The gate can be opened and closed remotely (2 remote controls included) or other access control devices such as access buttons or access keypads can be connected.

Obstacle detection

To avoid accidents, two sensitivity levels can be set: high and low. If the gate is closing or opening and encounters an obstacle, the motor will stop.

Automatic shutdown

You can program the gate to close automatically after a certain number of seconds (10, 30 or 60). You can also program the condominium mode that allows simultaneous control from multiple access devices.

In condominium mode, when the gate is opening, if the buttons on the remote control or other connected access terminal (access button or access keypad) are pressed, they will not work until the gate is fully open. When the gate is closing, if the buttons on the remote control or other connected access terminal are pressed, the gate will stop and open fully, allowing access.

Installation precautions

Do not weld when:

- it is mounted on the bearing sets (the bearing contact is damaged);

- the engine is mounted (it leads to the failure of the board and the wiring on it).